RAD Data comm 100 Specifikace stáhnout pdf (Strana 268)

Chapter 7 Application Tutorial Installation and Operation Manual

7-24 IP DSLAM and WiMAX Backhauling over SDH/SONET Egate-100 Ver. 4.0

Figure

7-30. Locking the SFP Wire Latch

2. Carefully remove the dust covers from the SFP slot.

3. Insert the rear end of SFP into the socket, and push slowly backwards to

mate the connectors until the SFP clicks into place. If you feel resistance

before the connectors are fully mated, retract the SFP using the latch wire as

a pulling handle, and then repeat the procedure.

4. Remove the protective rubber caps from the SFP modules.

Connecting to Channelized T3 Equipment

The Egate-100 channelized T3 interface terminates in three pairs of

BNC connectors.

³ To connect the T3 interface:

• Connect Egate-100 to the T3 equipment using BNC cables terminated with

BNC connectors.

CONTROL

Egate-100

RDY

ALM

LINK

MNG-ETH

LIN K

ACT

GbE

ACT

LINK

DCE

CH1 CH2 CH3

Figure

7-31. T3 BNC Connectors

Connecting to SDH/SONET Equipment

The Egate-100 SDH/SONET network port terminates in a fiber optic interface with

LC connectors (SDH/SONET).

³ To connect the SDH/SONET network equipment:

• Connect Egate-100 to the SDH/SONET network equipment using a standard

fiber optic cable terminated with an LC connector. Refer to

Installing Fiber

Optic SFP Modules

for details on installing fiber optic SFPs.

1 2 ... 263 264 265 266 267 268 269 270 271 272 273 ... 317 318

Žádné komentáře

RAD Data comm 100 Specifikace Strana 268