RAD Data comm 100 Specifikace stáhnout pdf (Strana 22)

Quick Start Guide Installation and Operation Manual

Starting a Terminal Session for the First Time

³ To start a terminal configuration session:

1. Connect an ASCII terminal to the CONTROL port on the front panel. The

default settings are as follows:

 Baud Rate: 115,200 bps

 Data Bits: 8

 Parity: None

 Stop Bits: 1

 Flow Control: None.

2. To optimize the view of the system menus, do the following:

 Set the terminal emulator to VT100.

 If you are using HyperTerminal, set the terminal mode to the 132-column

mode.

3. Power up Egate-100 and verify that the PWR LED on the front panel is on.

4. Verify the unit's correct startup by observing one of the following:

 From the ASCII terminal verify that the Self-Test was successfully

completed

 Check the ALM LED on the front panel of the unit:

 Off – No alarms

 On – Device alarm.

5. If the ALM LED is on, check the physical connections.

6. Press any key to display the Login screen.

7. Enter the user name and the password and proceed with the management

session.

The default user names are su and user. The default password is 1234. Only su

has permission to modify configuration parameters and download new software

versions.

Configuring Basic Parameters

The Quick Setup menu allows you to configure mandatory elements. For

additional information on parameters and the menus, refer to

Chapter 4

Configuration via the Quick Setup Menu

Note

³ To configure the required parameters using the Quick Setup menu:

1. Navigate to Main Menu > Configuration > Quick Setup.

The Quick Setup appears as illustrated below.

2 Configuring Egate-100 Egate-100 Ver. 4.0

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 317 318

Žádné komentáře

RAD Data comm 100 Specifikace Strana 22