RAD Data comm 100 Specifikace stáhnout pdf (Strana 240)

Chapter 6 Software Upgrade Installation and Operation Manual

6-6 Upgrading Egate-100 Software via the Boot Menu Egate-100 Ver. 4.0

The Boot menu procedures are recommended only for use by authorized

personnel, because this menu provides many additional options that are intended

for use only by technical support personnel.

The following software download option is available from the Boot menu:

• Downloading using the XMODEM protocol. This is usually performed by

downloading from a PC directly connected to the CONTROL DCE port of the

unit.

Figure

6-4. Downloading a Software Application File to Egate-100 via XMODEM

• Downloading using the TFTP. This is usually performed by downloading from a

remote location that provides an IP communication path to an Ethernet port

of Egate-100.

Figure

6-5. Downloading a Software Application File to Egate-100 via TFTP

Accessing the Boot Menu

Use the following procedure to access the boot menu before starting the

software upgrade.

1. Verify that Egate-100 4.0B.img is stored on the PC with the terminal

application.

2. Configure the communication parameters of the selected PC serial port for

asynchronous communication for 115.2 kbps, no parity, one start bit, eight

data bits and one stop bit. Turn all types of flow control off.

3. Turn off Egate-100.

4. Activate the terminal application.

5. Turn on Egate-100 and immediately start pressing the <Enter> key several

times in sequence until you see the Boot screen. A typical screen is shown

below (the exact version and date displayed by your Egate-100 may be

different).

Caution

1 2 ... 235 236 237 238 239 240 241 242 243 244 245 ... 317 318

Žádné komentáře

RAD Data comm 100 Specifikace Strana 240