RAD Data comm FCD-IP Uživatelský manuál stáhnout pdf (Strana 73)

RADview FCD-IP User’s Manual Chapter 3 Port Management

Configuring Network Parameters 3-35

Configuring the IP Routing Protocol

Configuring the IP routing protocol varies slightly, depending on the software

version you are running. The appropriate one of the following two options will

appear in the Network Parameters menu:

• IP Routing Protocol

• IP RIP Mode



To set IP Routing Protocol:

1. Select a link in which protocol type is not FR.

2. Select Configuration >Network Parameters > IP Routing Protocol…

The IP Routing Protocol dialog box appears.

Figure 3-25. IP Routing Protocol Dialog Box

Table 3-23. IP Routing Protocol Parameters

Parameter Possible Values / Remarks

Interface The selected interface.

For ISDN the parameters below will appear on two tabs: Channel 1 and Channel 2.

Routing Mode RIP 1: Send and receive routing information about IP nets only

RIP 2: Send and receive full routing information including subnets

RIP 1 & RIP 2: Send and receive both RIP 1 (routing information about IP nets only)

and RIP 2 (full routing information including subnets)

OSPF: Routing is determined by the OSPF protocol

No Routing Protocol

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 109 110

Žádné komentáře

RAD Data comm FCD-IP Uživatelský manuál Strana 73