RAD Data comm FCD-IP Uživatelský manuál stáhnout pdf (Strana 45)

RADview FCD-IP User’s Manual Chapter 3 Port Management

Configuring Interface Information 3-7

Figure 3-4. Interface Information Link Data Tab for E1/T1 over SHDSL

3. Click on the required tab.

4. Configure the desired parameters.

5. Click <Set>.

Table 3-5. Info Tab Parameters for E1/T1 over SHDSL

Parameter Possible Values / Remarks

Interface The selected interface.

Description Description of the selected interface.

Oper Status The operational status of link.

Up, Down

MTU The maximum Transmit Unit for IP fragmentation.

Frames lager than MTUare fragmented into smaller units when sent through the

specified interface

Changing the protocol type from Frame Relay (RFC 1490) to any other protocol will

cause the device to reset.

The following message appears “This operation will cause HW reset of the Device.

Continue?”

Click <OK> to confirm reset.

Note

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 109 110

Žádné komentáře

RAD Data comm FCD-IP Uživatelský manuál Strana 45