RAD Data comm FCD-IP Uživatelský manuál stáhnout pdf (Strana 41)

RADview FCD-IP User’s Manual Chapter 3 Port Management

Configuring Interface Information 3-3

Figure 3-2. Interface Information Link Data Tab

• Link Data tab is disabled for Sub and Voice links.

• Changing the protocol type from Frame Relay (RFC 1490) to any other protocol

will cause the device to reset.

The following message appears “This operation will cause HW reset of the

Device. Continue?”

Click <OK> to confirm reset.

Table 3-2. Interface Information Link Data Tab Parameters

Parameter Possible Values / Remarks

Interface The selected interface.

State Enable, Disable, Backup (only if there is more than one link)

Backup of Link The combo box listing links in current configuration.

Note: This field is disabled for SUB links

Link Type

Synchronous

Asynchronous (only for V.24 connector)

Protocol Type

(not available for

the SUB LINK or

CHANNEL)

Slip, Cslip, PPP

, HDLC Framing, RFC 1490

Notes

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 109 110

Žádné komentáře

RAD Data comm FCD-IP Uživatelský manuál Strana 41