RAD Data comm FCD-V35 Specifikace Strana 207

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 228
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 206
Installation and Operation Manual Appendix D Supervision Terminal Commands
FCD-E1LC Ver. 1.0 Commands D-41
Use
To display the hardware test report, type:
DSP HDR TST<Enter>
The display has one field that shows NO HARDWARE FAILURE if everything checks
well, or lists the detected problem: EPROM FAILURE, I/O EXP FAILURE, COUNTER
FAILURE, ILLEGL SYS CNFG or SFIFO FAIL.
DSP MANAGER LIST
Purpose
Display the network management stations to which the SNMP agent of this
FCD-E1LC system sends traps. The information that is provided for each network
management station includes its IP address and the corresponding subnet mask.
Syntax
DSP MANAGER LIST
Use
To display the current list of network management stations, type:
DSP MANAGER LIST<Enter>
You will see the list of network management stations that receive traps
generated by this FCD-E1LC system. A typical display is shown below:
MANAGERS LIST PARAMETERS
MANAGER 1 IP ADDRESS IS : 192.114.029.209
MANAGER 1 SUBNET MASK IS : 255.255.255.240
MANAGER 2 IP ADDRESS IS : 192.168.238.196
MANAGER 2 SUBNET MASK IS : 255.255.255.000
MANAGER 3 IP ADDRESS IS : 192.168.238.244
MANAGER 3 SUBNET MASK IS : 255.255.255.240
MANAGER 4 IP ADDRESS IS : 192.114.027.036
MANAGER 4 SUBNET MASK IS : 255.255.255.000
MANAGER 5 IP ADDRESS IS : 192.168.238.061
MANAGER 5 SUBNET MASK IS : 255.255.255.240
DSP PM ML
Purpose
Display the contents of the main link performance monitoring registers specified
by AT&T Pub. 54016. For an explanation of the performance monitoring registers,
refer to the
Performance Diagnostic Data
section in
Chapter 4
.
Zobrazit stránku 206
1 2 ... 202 203 204 205 206 207 208 209 210 211 212 ... 227 228

Komentáře k této Příručce

Žádné komentáře