RAD Data comm HCD-E1 Specifikace stáhnout pdf (Strana 71)

HCD-E1 Installation & Operation Manual Chapter 3 - Front Panel Operating Instructions

11/01/00 19:52 Configuration Parameters 3-13

Table 3-4 Control Port Parameters (Cont.)

Designation Function Values Configuration Guidelines

PARITY

Selects the

method of parity

checking

ODD Odd parity

EVEN Even parity

NONE Parity check disabled (available only with 8 data bits)

Default: NONE

Make sure that the parity is the same as on the

terminal.

INTERFACE

Selects control

port interface

DCE HCD-E1 operates as a DCE for the control terminal.

DTE HCD-E1 operates as a DTE, for connection via modem

to the control terminal.

Default: DCE

Select DCE when directly connected to the

control terminal.

Select DTE when connected to a modem.

Note: The INTERFACE parameter changes only the direction of the interface control (handshaking) signals, but not the functions of the

interface pins. Therefore, when connecting to a modem, it is necessary to use a cross cable.

AUX DEV (does

not appear

with HCD-E1

configured as

remote)

Selects the

management

mode supported

by the HCD-E1

control port

TERMINAL Management by means of a supervision terminal.

NMS-SLIP Management by means of Telnet host or an

SNMP network management station.

NONE Not in use

Default: TERMINAL

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 231 232

Žádné komentáře

RAD Data comm HCD-E1 Specifikace Strana 71