RAD Data comm E1 Interface Converter RIC-E1 Specifikace Strana 23

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 94
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 22
RIC-E1 Installation and Operation Manual Chapter 2 Installation and Setup
Configuring RIC-E1 2-3
BAL
BNC
LOC
AMI
HDB3
DTE
JP11
JP9
ANA LOOP
BAL
BNC
JP6
JP1
JP2
JP3
JP4
TX & RX CODE
INT
EXT
RCV
J4
Figure 2-1. RIC-E1 Jumper Locations
Table 2-1. RIC-E1 Jumper Settings
Jumper Description Values Default Setting
JP1, JP2, JP3, JP4,
JP6
Select the E1 interface type BAL – Balanced interface
(RJ-45 connector)
BNC – Unbalanced interface (BNC
coax connectors)
BAL
TX & RX CODE,
JP9
Selects the transmit and
receive coding
AMI – Jumper plug is installed
HDB3 – Jumper plug is not installed
HDB3
TIMING, J4 Selects the clock reference RCV (pin 4) – Receive clock
EXT (pin 5) – External clock
INT (pin 6) – Internal clock
RCV
Note: Units with the IR-ETH, IR-ETH/QN and IR-IP interface modules support only receive and internal clocks.
ANA LOOP, JP11 Controls the local analog
loopback activation
LOC – Activates the local analog
loopback
DTE – Allows the activation of the
local analog loopback via DTE
DTE
Zobrazit stránku 22
1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 93 94

Komentáře k této Příručce

Žádné komentáře