RAD Data comm FCD-X21 Instalační manuál Strana 205

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 224
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 204
Installation and Operation Manual Appendix D Command Language
FCD-E1 Supervisory Terminal Commands D-43
Syntax
EXIT
Use
To end the current communication session, type:
EXIT<Enter>
F
Purpose
Define the codes used to send to the supervision terminal to perform the following
terminal control functions:
Clear screen.
Move cursor to screen home position.
Move cursor to the right by one position.
If you have a TV920, VT52, VT100, Freedom 100/110 or Freedom 220 terminal,
you can use the DEF TERM command to set the control codes for that terminal.
Syntax
F
Use
1. To display the current codes, type:
F<Enter>
The terminal function entry screen is displayed. The screen includes three
separate lines, displayed one after the other. A typical screen, showing all
the three lines, is shown below:
CLEAR SCREEN =hhhhhhhh
CURSOR HOME =hhhhhhhh
CURSOR RIGHT =hhhhhhhh
where h indicates hexadecimal digits.
2. To change a code, enter the appropriate hexadecimal digit under the first digit
of the code, the cursor advances to the next digit.
3. Repeat the procedure until all the necessary digits are changed, and then press
<Enter> to end.
HELP
Purpose
Display an index of the supervision terminal commands used in the explicit mode,
and the options available for each command.
Syntax
HELP or H
Zobrazit stránku 204
1 2 ... 200 201 202 203 204 205 206 207 208 209 210 ... 223 224

Komentáře k této Příručce

Žádné komentáře