RAD Data comm E1/T1 Uživatelský manuál stáhnout pdf (Strana 51)

FCD-IPM Installation and Operation Manual Chapter 4 Configuration

Quick Setup Menu 4-3



To view the options:

• Toggle with the space bar and press ENTER.



To enter new information:

1. Type in the new parameters.

2. Press <Enter>.



To change the existing value:

• Press <Backspace>.

After all parameters have been accepted or changed, you can view them on the

screen. A confirmation message appears requesting that you confirm all the setup

changes. The device may reset after saving these changes.



To configure the setup parameters:

1. From the Main Menu, select option 1, Quick Setup.

2. Follow the on-screen instructions to accept or modify the setup parameters.

3. Press Y to save the setup parameters.

Quick Setup Parameters

The Quick Setup menu contains both general parameters and those parameters

specific to the interfaces installed. This section organizes the parameters into

various categories. The screen for each interface and a description of the options

in the Quick Setup menu can be found in the sections that follow. Refer to the

section that applies to the interface you ordered.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 223 224

Žádné komentáře

RAD Data comm E1/T1 Uživatelský manuál Strana 51